Toro ProForce 44538 Service Manual page 82

3. Install the wheel hub onto the axle spindle taking
care to not damage grease seal in hub.
4. Install greased outer bearing cone, tab washer and
jam nut onto spindle shaft.
5. While rotating the wheel hub by hand, torque the jam
nut from 75 to 180 in-lb (8.5 to 20.3 N- -m) to seat bear-
ings. Loosen nut until it is away from tab washer and hub
has end play. Finally, while rotating hub, tighten jam nut
from 15 to 20 in- -lbs (1.7 to 2.3 N- -m).
6. Install nut retainer and cotter pin to secure jam nut.
Install dust cap to hub.
WARNING
Failure to maintain proper lug nut torque could
result in failure or loss of wheel and may result in
personal injury.
Chassis
7. Install wheel assembly (see Wheel Installation in this
section).
8. Carefully lower machine to ground. Make sure to
properly torque wheel lug nuts from 70 to 90 ft- -lb (95
to 122 N- -m).
9. Connect negative battery cable to negative battery
terminal. Tighten nut that secures battery cable from 10
to 15 ft- -lb (14 to 20 N- -m). Make sure that battery cover
is secured.
Page 6 - - 8 Rev. B ProForce Debris Blower