Hard Drive - HP ENVY Maintenance And Service Manual

Hard drive

NOTE: The hard drive spare part kit does not include the hard drive bracket, hard drive cable, or screws.
Description
2-TB, 5400-rpm, SATA, 9.5-mm, 2.5-in
1-TB, 5400-rpm, SATA, 7.0-mm, 2.5-in
750-GB, 5400-rpm, SATA, 7.0-mm, 2.5-in
500-GB, 5400-rpm, SATA, 7.0-mm, 2.5-in
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Remove the hard drive:
1. Disconnect the battery cable from the system board.
2. Release the zero insertion force (ZIF) connector (1) to which the hard drive cable is connected, and then
disconnect the hard drive cable from the system board.
3. Remove the four Phillips PM2.0×3.3 screws (2) that secure the hard drive to the computer.
30 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Bottom cover on page 28).
Spare part number
801808-005
833907-005
778190-005
778188-005