Display Assembly; Rj45 Cover; Security Cable Slot Bracket; System Board - HP ENVY Maintenance And Service Manual

c. RJ45 cover (see
d. Security cable slot bracket (see
e. System board (see
Remove the power connector cable:
1. Remove the Phillips PM2.0×3.3 screw (1) that secures the power connector cable and bracket to
the top cover.
2. Remove the power connector cable bracket (2).
The power connector cable bracket is available using spare part number 818117-001.
3. Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.

Display assembly

Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the RJ45 cover (see
7. Remove the security cable slot bracket (see
Remove the display assembly:
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
RJ45 cover on page 49)
Security cable slot bracket on page
System board on page
Bottom cover on page
RJ45 cover on page
Security cable slot bracket on page
52)
28).
Battery on page
49).
51)
38).
51).