Panasonic WV-SFR631L Operating Instructions Manual page 146

16 Configuring the network settings [Network]
[Max RTP packet size]
Select "Unlimited(1500byte)" or "Limited(1280byte)" to determine whether or not to restrict the RTP packet size
when viewing images from the camera using the RTP protocol. It is recommended to use with the default
"Unlimited(1500byte)".
When the RTP packet size is restricted in the network line in use, select "Limited(1280byte)". Refer to the
network administrator for further information about the maximum packet size in the network line.
•
Default: Unlimited(1500byte)
[HTTP max segment size(MSS)]
Select "Unlimited(1460byte)", "Limited(1280byte)", or "Limited(1024byte)" to determine whether or not to
restrict the maximum segment size (MSS) when viewing images from the camera using the HTTP protocol.
We recommended that you use this feature with the default setting.
When the MSS is restricted in the network line in use, select "Limited(1024byte)" or "Limited(1280byte)". Refer
to the network administrator for further information about the MSS in the network line.
•
Default: Unlimited(1460byte)
[Bandwidth control(bit rate)]
Select the total bit rate for data transmission from the following.
Unlimited/ 64kbps/ 128kbps/ 256kbps/ 384kbps/ 512kbps/ 768kbps/ 1024kbps/ 2048kbps/ 4096kbps/
8192kbps
•
Default: Unlimited
Note
•
When selecting "64kbps", select "Off" for "Audio transmission/reception" on the "Audio" tab.
(®page 110)
•
Select "128kbps" or a faster rate to carry out the live transmission of JPEG images and the FTP periodic
image transmission simultaneously.
•
When "Bandwidth control(bit rate)" is set low, taking a picture using the snap shot button may not
function depending on the usage environment. In this case, select "JPEG" with the [Compression]
button on the "Live" page and take a picture with the snap shot button using the lowest possible image
capture size.
[Easy IP Setup accommodate period]
Select "20min" or "Unlimited" to determine how long the network setting operation using the Panasonic "IP
Setting Software" can be allowed.
•
20min: The network setting operation using the Panasonic "IP Setting Software" are allowed for 20 minutes
since the camera starts up.
•
Unlimited: The network setting operation using the Panasonic "IP Setting Software" are allowed without
time limitation.
•
Default: 20min
Note
•
The camera information display using the Panasonic "IP Setting Software" is allowed without time
limitation, and camera images can be opened.
•
Refer to the network administrator for the addresses of each server.
•
The port forwarding function changes a global IP address to a private IP address, and "Static IP
masquerade" and "Network Address Translation (NAT)" have this function. This function is to be set in
a router.
146 Operating Instructions