Table of Contents
Advertisement
Display cable
Description
Display cable
eDP bracket (included in Bracket Kit, spare part number 840966-001)
Before removing the display cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the service door (see
5.
Remove the bottom cover (see
6.
Disconnect the battery (see
Remove the display cable:
1.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the display cable to the computer.
2.
Lift the eDP bracket from atop the connector (2).
3.
Disconnect the cable from the system board (3).
4.
Remove the cable from the clips along its routing path (4).
Reverse this procedure to install the display cable.
Service door on page
28).
Bottom cover on page
Battery on page
30).
29).
Component replacement procedures
Spare part number
840938-001
840966-001 (Bracket Kit)
45
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
