Rtc Battery - HP ZBook Studio G 315-ap000 – 15ap099 Maintenance And Service Manual

RTC battery

Description
RTC battery (includes cable and double-sided adhesive)
Before removing the RTC battery, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the bottom cover (see
6. Disconnect the battery (see
7. If installed, remove the hard drive (see
Remove the RTC battery:
1. Disconnect the RTC battery cable (1) from the system board.
2. Detach the RTC battery (2) from the base enclosure. (The RTC battery is attached to the base enclosure
with double-sided adhesive.)
3. Remove the RTC battery and cable.
Reverse this procedure to install the RTC battery.
38 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Service door on page 28).
Bottom cover on page
Battery on page 30).
Hard drive on page
29).
32).
Spare part number
840953-001