Wlan Module - HP ZBook Studio G 315-ap000 – 15ap099 Maintenance And Service Manual

WLAN module

Description
Intel Dual Band Wireless-AC 8260 3rd Gen Intel 802.11ac, Dual Band, 2x2 Wi-Fi + Bluetooth 4.2
Intel Dual Band Wireless-AC 8260 3rd Gen Intel 802.11ac, Dual Band, 2x2 Wi-Fi + Bluetooth 4.2 (non-
vPro)
CAUTION:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the bottom cover (see
6. Disconnect the battery (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board. (The
WLAN module tilts up.)
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Service door on page
Bottom cover on page
Battery on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
28).
29).
30).
Spare part number
806721-001
806722-001