Display Panel Cable - HP Envy x2 Maintenance And Service Manual

Display panel cable

Description
Display panel cable (includes double-sided adhesive)
Before removing the display panel cable, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
the following components:
Battery (see
▲
Remove the display panel cable:
1. Release the ZIF connector (1) to which the display panel cable is connected, and then disconnect
the display panel cable from the system board.
2. Detach the display panel cable (2) from the back cover. (The display panel cable is attached to
the back cover with double-sided adhesive) and remove the cable (3).
3. Remove the display panel cable.
Reverse this procedure to install the display panel cable.
Display panel assembly on page
Battery on page 36)
Spare part number
L05102-001
32), and then remove
Component replacement procedures 43