4.
Remove the fan/heat sink assembly (5).
CAUTION:
the fans.
Discrete models:
UMA models:
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink assembly
and the system board components each time the fan/heat sink assembly is removed. Replacement thermal
material is included with the thermal module, processor, and system board spare part kits.
Discrete graphics models:
●
Various thermal pads are used on the system board components and the heat sink sections and that
service them. See the following image for thermal pad locations.
40
Chapter 6 Removal and replacement procedures for authorized service provider parts
When lifting the heat sink out of the computer, be careful not to bend the arm that connects