Table of Contents
Advertisement
Display panel cable
Description
Display panel cable (includes adhesive support strip and double-sided adhesive)
Before removing the display panel cable, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the display panel assembly (see
Remove the display panel cable:
1.
Disconnect the display panel cable (1) from the system board.
2.
Release the ZIF connector (2) to which the display panel ribbon cable is attached, and then disconnect
the display panel ribbon cable from the TouchScreen board.
3.
Detach the display panel cable (3) from the back cover. (The display panel cable is attached to
the back cover with double-sided adhesive.)
4.
Release the display panel cable from the retention clips (4) built into the battery.
5.
Remove the display panel cable (5).
Reverse this procedure to install the display panel cable.
Display panel assembly on page
Component replacement procedures
Spare part number
830337-001
20).
27
Hide quick links:
Advertisement
Table of Contents
