Installing the optional color wheel
The projector comes with a four-segment color wheel installed. An additional six-segment color
wheel is optional. To replace the color wheel (located under the lamp cover adjacent to lamp 1)
refer to the following guide.
Wait until the lamp house and the color wheel cool off.
1. Turn the power off and disconnect the
projector from the power outlet. Turn off
all connected equipment and disconnect all
other cables.
2. Remove the screws on the lamp cover (A),
and slide the lamp cover as shown (B).
B
A
3. Unscrew the retaining screws (x 4) on the
four-segment color wheel.
4. Lift the color wheel in the direction shown.
5. Insert the six-segment color wheel.
6. Secure the retaining screws as shown, and
then close the lamp cover.
55