Choosing A Location - BenQ PX9510 User Manual

Choosing a location

Your projector is designed to be installed in one of four possible installation locations.
Your room layout or personal preference will dictate which installation location you select. Take
into consideration the size and position of your screen, the location of a suitable power outlet, as
well as the location and distance between the projector and the rest of your equipment.
1. Front Table:
Select this location with the projector
placed near the floor in front of the screen.
This is the most common way to position
the projector for quick setup and portability.
2. Front Ceiling:
Select this location with the projector
suspended from the ceiling in front of the
screen. Purchase the BenQ Projector Ceiling
Mount Kit from your dealer to mount your
projector on the ceiling.
* To set the projector position:
and then press ◄/► until
MENU
Press
Press ▲/▼ to highlight
selected.
• Ceiling installation must be done by a qualified professional. Contact your dealer for more information. It is not
recommended you install the projector yourself.
• Only use the projector on a solid, level surface. Serious injury and damage can occur if the projector is dropped.
• Do not use the projector in an environment where extreme temperature occurs. The projector must be used at
temperatures between 41 degrees Fahrenheit (5 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).
• Screen damage will occur if the projector is exposed to moisture, dust or smoke.
• Do not cover the vents on the projector. Proper ventilation is required to dissipate heat. Damage to the projector
will occur if the vents are covered.
16
INSTALLATION
Projector Installation
3. Rear Table:
Select this location with the projector
placed near the floor behind the screen.
Note that a special rear projection screen is
required.
70cm
4. Rear Ceiling:
Select this location with the projector
suspended from the ceiling behind the
screen. Note that a special rear projection
screen and the BenQ Projector Ceiling
Mount Kit are required for this installation
location.
70cm
menu is highlighted.
and press ◄/► until the correct position is