Toshiba e-studio 167 Service Manual page 75

• When paper becomes almost empty as they fed out during copying,
The tray-up sensor is turned OFF.
The tray-up motor is turned ON – the tray is raised.
The tray-up sensor is turned ON.
The tray-up motor is stopped.
• When the paper empty sensor is turned OFF even if the tray-up sensor is ON during copying,
The sensor is detecting that no paper exists.
The lamp on the control panel corresponding to the drawer blinks (When the drawer is
selected)
Copying is stopped
(B) Pick-up failure in bypass
• During bypass feeding
Bypass pickup solenoid ON
Registration sensor is not turned ON in a fixed period of time
"Misfeed in bypass" is displayed : E12
Copying operation is disabled
Solution: The bypass paper sensor is turned OFF by removing the paper from the bypass tray.
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
4 - 7
e-STUDIO167/207/237
GENERAL OPERATION
4