Toshiba e-studio 167 Service Manual page 214

(7) Remove 2 bushings and 2 oil seals on the
rear side.
(Replacement of Oil seal:
Replacement of Oil Seal")
(8) Remove the end section of the mixer-1.
(9) Remove the bushing and oil seal.
(Replacement of Oil seal:
Replacement of Oil Seal")
(10) Take off the mixer-1.
e-STUDIO167/207/237
DEVELOPMENT SYSTEM
P.12-21 "[H]
End section of mixer-1
P.12-21 "[H]
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
12 - 20
Oil seal
Fig. 12-31
Bushing Oil seal
Fig. 12-32
Mixer-1
Fig. 12-33
Bushing