Toshiba e-studio 167 Service Manual page 236

(4) Take off each 1 pressure lever on both front
and rear sides.
(5) Take off 2 bushings and then take off the
pressure roller while sliding the pressure
roller to the rear side.
Notes:
• Do not drop the pressure roller when you
lift it up because it is quite heavy.
• Be sure to install the pressure roller from
the rear side (pressure roller ground plate
side) in order not to deform the pressure
roller ground plate.
[I] Center thermistor / Side thermistor / Edge thermistor (THMS1/THMS2/THMS3)
(1) Take off the fuser roller.
P.13-18 "[G] Fuser roller"
(2) Remove each 1 screw of the thermistors,
and then take off each thermistor by releas-
ing its harness out of the harness clamp.
e-STUDIO167/207/237
FUSER / EXIT UNIT
Bushing
Pressure roller
ground plate
Thermistor
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
13 - 20
Pressure lever
Fig. 13-29
Pressure roller
Bushing
Fig. 13-30
Fig. 13-31