Toshiba e-studio 167 Service Manual page 182

[B] Drum cleaner unit
(1) Take out the process unit.
P.11-9 "[A] Process unit"
(2) Disconnect 2 connectors and remove 2
screws.
(3) Release 1 latch. Then pull out the process
unit front cover and take it off.
Note:
When installing the process unit front cover,
wire the harness correctly in order not to con-
tact the gears and harness of the process
unit front cover each other.
e-STUDIO167/207/237
DRUM RELATED SECTION
for MJD
Latch
Process unit front cover
except for MJD
Latch
Process unit front cover
Harness
Process unit
front cover
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
11 - 10
07/03
Connector
Connector
Fig. 11-8
Connector
Connector
Fig. 11-9
Fig. 11-10