Throttle Hold Function (Hold)- (Heli Only) - FUTABA 6J Instruction Manual

appears on screen.
4) The LCD screen will contain the pitch curve point indication (left side of screen), as well as the current
pitch curve value, expressed as a percentage of travel, on the right side of the display.
Note: Point 1 is shown initially which is throttle stick all the way downward (slow)
position. Point 5 is throttle stick all the way upward (hi) position.
Press the DATA INPUT lever upward to increase the percentage of servo travel for
the respective point on the pitch curve. Press the DATA INPUT lever downward to
decrease the percentage of servo travel for the respective point on the pitch curve.
5) Press the SELECT button one time to bring up the point two (2) pitch curve adjustments. Again, use the
DATA INPUT lever to adjust the values accordingly.
6) Repeat the previous steps to set the normal pitch curve point values for the remaining three (3) points.
7) Press and hold the END button to exit the programming mode.

Throttle hold function (HOLD)- (HELI only)-

Throttle hold function is typically used for autorotations where only pitch control is used to make a descent
DQG ODQGLQJ 7KLV LV DOVR D JRRG VDIHW\ IHDWXUH WR XVH ZKLOH FDUU\LQJ WKH PRGHO WR WKH ÀLJKW OLQH DIWHU VWDUWLQJ
WKH HQJLQH RU DV D ¿QDO DUPLQJ IRU DQ HOHFWULFSRZHUHG PRGHO -XVW ÀLS WKH KROG VZLWFK RQ WR VHW WKH HQJLQH
LQ WKH LGOLQJ RU FXW SRVLWLRQ DQG GLVHQJDJH LW IURP WKH WKURWWOH VWLFN 7KH WKURWWOH VHUYR¶V SRVLWLRQ FDQ EH VHW
IURP  WR  IURP WKH WKURWWOH WULP SRVLWLRQ
Note: The collective servo remains active to allow for pitch inputs during the descent of the helicopter.
To set the throttle hold:
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode. An audible double beep will be heard
and the default screen will change accordingly.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the throttle hold (HOLD) menu
appears on screen.
 7KH ULJKW VLGH RI WKH /&' VKRXOG LQGLFDWH WKDW WKH WKURWWOH KROG LV LQKLELWHG DV GHQRWHG E\ WKH ÀDVKLQJ
INH. Activate the throttle hold by pressing and holding the DATA INPUT lever upward. The INH should
52