Greasing The Steering Head Bearing; Removing The Start Number Plate (Freeride E-Sx) - KTM Freeride E-SX Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.13

Greasing the steering head bearing

12.14 Removing the start number plate (Freeride E‑SX)
–
Mount and tighten screw
Guideline
Screw, top steering stem
(Freeride E‑XC)
–
Release screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
C00803-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the play of the steering head.
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
C00760-01
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Remove screw
–
Remove screw
–
Take off the start number plate.
C00720-10

.
M8
 
. Remove screw

.

.

.
M8
(
p. 94)
p. 63)
( p. 54)
( p. 55)
p. 37)
p. 63)
p. 94)
p. 64)

and take off the clamp.
 .
17 Nm Loctite
(12.5 lbf ft)
.
M20x1.5 12 Nm
(8.9 lbf ft)
M8 22 Nm
(16.2 lbf ft)
17 Nm Loctite
(12.5 lbf ft)
p. 59)
p. 49)
60
® 243™
® 243™