12
SERVICE WORK ON THE CHASSIS
–
Mount and tighten screw
Guideline
Screw, top steering stem
C00830-10
–
Tighten screws
Guideline
Screw, top triple clamp
C00833-11
–
Attach the brake line and close the holder
C00829-10
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake
caliper
–
Position the brake line, wiring harness, and clamp. Mount and tighten
screws
–
Connect the plug-in connector of the speedometer sensor and mount the cable
tie(s).
C00837-10
Finishing work
–
Install the front fender. (
(Freeride E‑SX)
–
Install the start number plate. (
(Freeride E‑XC)
–
Refit the headlight mask with the headlight. (
–
Install the front wheel.
–
Check that the cable and brake lines are routed correctly.
–
Check the play of the steering head.
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
(Freeride E‑XC)
–
Check the headlight setting. (
.
M8
.
M8
.
p. 61)
(
p. 81)
p. 94)
p. 63)
p. 92)
17 Nm
Loctite
(12.5 lbf ft)
M8
22 Nm
(16.2 lbf ft)
.
with the spacers.
25 Nm
Loctite
(18.4 lbf ft)
p. 61)
p. 90)
(
p. 59)
p. 49)
58
®
243™
®
243™