13
BRAKE SYSTEM
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Move the brake fluid reservoir attached to the right of the handlebar to a horizontal
position.
–
Remove screws
–
Remove cover
C00724-11
–
Remove screws
(Freeride E‑XC)
–
Remove the cable tie(s).
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc.
–
Carefully pull the brake caliper backward from the brake disc.
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir, extracting brake fluid if necessary.
C00725-10
–
Remove cotter pins
–
Remove pins
–
Take off retaining spring
–
Clean the brake caliper.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
C00726-10
–
Position retaining spring
–
Mount pin
Info
To make it easier to mount the pin, push the retainer spring down.
Make sure the retaining spring is seated correctly.
–
Mount cotter pins
–
Position the brake caliper. Mount screws
yet.
–
Operate the front brake lever several times until the brake linings are in contact
with the brake disc and there is a pressure point. Secure the front brake lever in
the activated position.
The brake caliper straightens.
–
Tighten screws
Guideline
Screw, front brake caliper
C00725-10
–
Remove the fixation for the front brake lever.
(Freeride E‑XC)
–
Mount the cable tie(s).
p. 94)
p. 64)
.
with membrane
and spacers.
.
.
and remove the brake linings.
.
.
.
.
M8
.
with the spacers but do not tighten
25 Nm
Loctite
(18.4 lbf ft)
75
®
243™