12
SERVICE WORK ON THE CHASSIS
12.32
Checking the frame
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
C00827-01
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
»
If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
C00710-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Check the frame for cracking and deformation.
»
If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame.
402151-01
p. 94)
p. 63)
p. 37)
p. 63)
p. 94)
p. 64)
Info
A frame that has been damaged due to a mechanical impact must
be replaced. Repair of the frame is not authorized by KTM.
M8
15 Nm
(11.1 lbf ft)
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
p. 49)
69