15
ELECTRICAL SYSTEM
15.8
Changing the turn signal bulb (Freeride E‑XC)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
–
Press headlight bulb
pull it out.
–
Insert the new headlight bulb.
Headlight (S2/socket BA20d) (
–
Insert the rubber cap with the bulb socket into the reflector and turn it clockwise
all the way.
Info
Ensure that O-ring
C00814-10
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Refit the headlight mask with the headlight. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
–
Check the headlight setting. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
C00816-10
–
Lightly squeeze together the orange cap
it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
C00817-10
Turn signal (R10W/socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. (
lightly into the bulb socket, turn it counterclockwise, and
p. 115)
is seated properly.
p. 94)
p. 63)
p. 92)
p. 37)
p. 63)
p. 94)
p. 64)
.
in the area of the holding lugs and take
p. 115)
p. 94)
p. 63)
p. 90)
91