KTM Freeride E-SX Owner's Manual page 50

11 TUNING THE CHASSIS
0 0
0 0
Main work
–
Remove screws
–
Take off the handlebar and hang to the side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
C00761-10 Place the handlebar supports in the required position. Mount and tighten

screws
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap widths are even.
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. (

. Take off the handlebar clamps.

. Take off the handlebar supports.
.
M10
p. 94)
p. 63)
40 Nm Loctite
(29.5 lbf ft)

and tighten evenly.
M8 20 Nm
(14.8 lbf ft)
48
® 243™