12
SERVICE WORK ON THE CHASSIS
12.6
Installing the fork legs
Main work
(Freeride E‑SX)
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
C00689-10
–
Release screws
–
Release screws
C00690-10
(Freeride E‑XC)
–
Remove screws
–
Remove the cable tie(s) and detach the plug-in connector of the speedometer
sensor.
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
C00797-10
–
Release screws
–
Release screws
C00798-10
Main work
(Freeride E‑SX)
–
Position the fork legs.
Bleeder screws
C00687-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
C00690-11
and take off the clamp.
and the spacers and take off the brake caliper.
. Take out the left fork leg.
. Take out the right fork leg.
and take off the clamp.
and the spacers and take off the brake caliper.
. Take out the left fork leg.
. Take out the right fork leg.
face forward.
Info
The lowest milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
The support for the brake caliper is attached to the left fork leg.
.
.
M8
22 Nm
(16.2 lbf ft)
M8
18 Nm
(13.3 lbf ft)
51