Charging The Ktm Powerpack In The Storage Charging Mode - KTM Freeride E-SX Owner's Manual

16 KTM POWERPACK, BATTERY CHARGER
16.6

Charging the KTM PowerPack in the Storage charging mode

Note
Material damage The power supply will be damaged in the event of an overload.
In the Storage charging mode, a steady current of at least 10 A is required.
–
Ensure that the power outlet can supply the steady current required and is protected by a suitable fuse.
Warning
Environmental hazard Lithium-ion batteries contain components and elements that are harmful to the environment.
–
Never throw a KTM PowerPack into the household trash.
–
Dispose of the KTM PowerPack properly and in compliance with the applicable regulations. (Your authorized KTM workshop
will be glad to help.)
Info
The charge level of the KTM PowerPack must be below 50% before the Storage charging mode can be used.
If the temperature of the KTM PowerPack exceeds the permissible value while it is being charged, the charger stops charging.
All LEDs and the LEDS for the current charge level alternately light up every second.
After the temperature of the KTM PowerPack returns to the permissible range, charging is resumed automatically.
–
Switch on the battery charger using the switch
The charging process starts automatically. The status indicator flashes during
the charging process.
C00769-10
–
Monitor the charging level of the KTM PowerPack using the LEDs.
LED 1: 20%
LED 2: 40%
LED 3: 60%
LED 4: 80%
LED 5 flashes beginning with approx. 95 % until 100 % is reached.
Once the charging process is complete, all five LEDs light up and the status indica-
tor goes out.
C00770-10
–
Switch off the battery charger using the switch
After several seconds, all LEDs on the battery charger go out.
–
Disconnect the power plug for the battery charger from the power supply socket.
–
Disconnect the charging cable from the KTM PowerPack.
Guideline
Pull on the structured part of the connector. Do not pull on the cable.
–
Check the seal on the charging socket protection cap.
» If the seal is dirty:
C00769-11
–
Clean the seal without using water or compressed air.
» If the seal is damaged or worn:
–
Change the seal.
–
Mount the charging socket protection cap.
Finishing work
–
Lock the seat. (
Preparatory work
–
Position the battery charger. (
p. 63)
p. 96)

.

.
98