Table of Contents
Advertisement
4
SERVICE WORK
4.13
Checking residual current protection switch
4.14
Recharging the KTM PowerPack
Note
Material damage The power supply will be damaged in the event of an overload.
In charge mode Fast, a steady current of at least 13 A is required.
In charge mode Normal, a steady current of at least 10 A is required.
–
Ensure that the power outlet can supply the steady current required and is protected by a suitable fuse.
Warning
Environmental hazard A lithium-ion battery (KTM PowerPack) contains components and elements that are harmful to the envi-
ronment.
–
Never throw a KTM PowerPack into the household trash.
–
Dispose of the KTM PowerPack properly and in compliance with the applicable regulations.
Info
The procedure used for recharging is identical both when the battery is installed and when it is not installed. However, the
12 V battery is only recharged when the KTM PowerPack is being recharged in the vehicle.
Recharge the KTM PowerPack regularly while it is inside the vehicle to also charge the 12 V battery.
When the battery charger is connected to the KTM PowerPack, do not activate the vehicle.
If the vehicle is activated while recharging with the KTM PowerPack installed in the vehicle, the vehicle will switch to error
mode. The KTM PowerPack will continue to be recharged, however the 12 V battery will stop recharging.
Info
When the left LED in the charge level indicator on the battery charger flashes, then the KTM PowerPack is ready for use. How-
ever, its full capacity will not yet be available.
To guarantee the maximum capacity of the KTM PowerPack, discharge the KTM PowerPack completely every 20 charging
cycles and then recharge it completely. If this process is not carried out, then the vehicle may switch off due to a charging
level which is too low without reducing power beforehand.
The KTM PowerPack is completely discharged when the vehicle switches off with blink code 11.
–
Place the battery charger on a firm, level and horizontal surface.
–
Ensure the battery charger is adequately ventilated.
Guideline
Free space at the front and rear side of
the battery charger
–
Use the battery charger in the temperature range permitted.
Guideline
Ambient temperature
C00766-01
–
Ensure that the power plug for the battery charger always remains easily accessible.
Warning
Risk of injury There is a risk of electric shock with a faulty residual current
protection switch.
–
–
–
Connect the mains plug to the mains connection.
K00031-10
–
Press the
The operating display lights up red.
–
Press the
The operating display goes out.
–
Press the
The residual current protection switch can be used.
–
Disconnect the residual current protection switch from the mains connection.
Before each use of the charger check the residual current protection
switch.
Do not use the residual current protection switch if the test procedure
was not successful.
button .
button .
button .
20 cm (7.9 in)
−15... 50 °C (5... 122 °F)
14
Advertisement
Table of Contents
