Setting Start Sequence Display; Setting Weld Sequence Display - Miller Electric Welder Owner's Manual

11-4. Setting Start Sequence Display

1
> Start
24.0 Volt
90 IPM
0.2 Sec
Parameter
Select
Increase
Proceed to next Section.

11-5. Setting Weld Sequence Display

1
> Weld
Induct 20
18.0 Volt
200 IPM
Parameter
Select
Weld
Induct 30
20.0 Volt
> 200 IPM
Parameter
Select
Set Desired Wire Feed Speed
Increase/
Decrease
Parameter
Weld
Induct 30
20.0 Volt
420 IPM
Start
> 18.0 Volt
90 IPM
0.2 Sec
Parameter
Set Desired Voltage
Increase/
Decrease
Start
18.0 Volt
200 IPM
0.5 Sec
Parameter
Select
Weld
> Induct 20
18.0 Volt
200 IPM
Weld
Induct 30
> 20.0 Volt
200 IPM
Select
> Weld
Induct 30
20.0 Volt
420 IPM
Start
18.0 Volt
> 200 IPM
0.2 Sec
Set Desired Wire
Feed Speed
Select
Increase/
Decrease
Start
18.0 Volt
200 IPM
> 0.5 Sec
Set Desired Time Parameter
Select
Increase/
Decrease
Set Desired
Inductance
Weld
> Induct 30
18.0 Volt
200 IPM
Increase/
Decrease
Parameter
Select
Set Desired
Voltage
Weld
Induct 20
> 18.0 Volt
200 IPM
Increase/
Decrease
Increase
Proceed to next Section.
1 Start Parameters Display
Parameter ranges are as follows:
Seconds, 0-2.5 Sec. If value set is
zero (0), there is no Run-In se-
quence. With zero (0) time value,
programmed values for volts and
wire feed speed are used until a val-
id arc condition is detected.
Volts, 10.0-38.0 Volts
Wire Feed Speed, 50-780 inches
per minute, IPM
Go on to Section 11-5.
1 Weld Parameters Display
Parameter ranges are as follows:
Inductance, 0-99
Volts, 10.0-38.0 Volts
Wire Feed Speed, 50-780 Inches
Per Minute, IPM
Go to Section 11-6.
OM-196 188 Page 97