Motor Start Control; Adjusting Control Tilt Bracket - Miller Electric Swingarc Owner's Manual

3-2. Motor Start Control

1
Tools Needed:
Non-Conductive
1/4 in

3-3. Adjusting Control Tilt Bracket

OM-1583 Page 10
2
3
3
To change wire feed starting speed
proceed as follows:
Turn Off unit and welding power
source.
Remove wrapper.
1 Front Panel
Remove screw from upper left cor-
ner, and open hinged front panel.
2 Motor Board PC1
3 Motor Start Control
Potentiometer R70
Rotate potentiometer clockwise to
increase time it takes the motor to
ramp up to speed. Remove protec-
tive white rubber cap before making
adjustment. Adjust potentiometer
R70 using a small nonconductive
screwdriver.
Close and secure front panel, and
reinstall wrapper.
152 378-B / Ref. SB-183 121-C
1 Tilt Bracket
2 Rear Pivot Screw
3 Front Screw
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
en pivot screw.
1
2
ST-801 279