Table of Contents
Advertisement
14-10. Selecting Wire Type
NOTE
Access
Setup
Display
Press Mode
Select
Arc Time
Wire feed
> Wiretype
Display
14-11. Defining Display Value
Access
Setup
Display
Press Mode
Select
Wirefeed
Wiretype
> Display
Memory
If wire type is changed, perform a system reset (see Section 14-12) immediately
after selecting wire type to bring up the correct welding programs.
.
After using system reset to store wire type selection into
memory, all other setup parameters return to factory default
settings. See Section 14-2 for procedure to return to setup
displays and reset parameters.
1
Wire Type
> Hardwire
System
Reset
Now
Increase
1
> Command
Increase
Increase
> Actual
Wire Type
> Softwire
System
Reset
Now
> Amps
1
Wire Type Display
Select soft wire when using
aluminum wire in the wire feeder.
Select hard wire when using any
other kind of wire.
1
Display Select Display
The display can show amps, actual
reading or print out command.
OM-196 188 Page 113
Advertisement
Table of Contents
Troubleshooting
