Setting Ramps Function; Software Version Number; Exiting The Setup Menu - Miller Electric Welder Owner's Manual

14-21. Setting Ramps Function

Access
Setup
Display
1
Press Mode
Select
Prog 2
> Start On
Crater Off
Parameter
Select
4
Prog 2
Start On
> Crater Off

14-22. Software Version Number

Press Mode
Select
Access
Setup
Display

14-23. Exiting The Setup Menu

Press Mode
Select
Access
Setup
Display
OM-196 188 Page 118
Monitor > Prog 1
Stick
> Ramps
Exit
Prog 2
> Start Off
Crater Off
Increase
3
Prog 2
Start On
> Crater On
Increase
Stick
Ramps
> Software
Exit
Stick
Ramps
Software
> Exit
2
Start Off
Crater Off
Increase
> Prog 2
Start
Crater
Parameter
Select
1
Version
# 123456Z
1
Exit Setup
Menu Now
Press
1 Ramps Display
The ramps function allows output
power to be tapered from start to
weld and/or from weld to crater.
2 Program Number
Choose the desired program num-
ber (1 through 8). Turns start and/or
crater ramping On or Off as desired.
3 Start Display
Turns start ramping On or Off as de-
fined.
4 Crater Display
Turns crater ramping On or Off as
defined.
Off
Off
1 Example Version Number
Display
When talking with
personnel, this number may be
required. (Check actual unit display
for number.) The factory keeps this
number on file with the serial num-
ber of the unit.
1 Exit Setup Menu Display
Allows user to exit setup menu with-
out cycling power.
service