Selecting Voltage Correction; Selecting Auxiliary Output; Selecting Voltage Sensing Method - Miller Electric Welder Owner's Manual

14-4. Selecting Voltage Correction

Access
Setup
Display
Press Mode
Select

14-5. Selecting Auxiliary Output

Access
Setup
Display
Press Mode
Select
Aux
Turn On
> w/Weld Cyc

14-6. Selecting Voltage Sensing Method

Access
Setup
Display
Press Mode
Select
Mig Type
Aux Out
> Voltage
ArcStart
OM-196 188 Page 110
Access
> Mig Type
Aux Out
Voltage
Access
Mig Type
> Aux Out
Voltage
Aux
Turn On
> w/Arc
Increase
1
Control
Feedback
> Internal
MIG
Voltage
Correction
> DVC Off
Increase
MIG
Voltage
Correction
> DVC On
Aux
Turn On
> Never
Increase
Aux
Turn On
> w/Feeder
Increase
Increase
Control
Feedback
> V Sense
1 Mig Type Display
With DVC Voltage Correction On,
1 the unit uses closed-loop feedback
or voltage sensing leads
maintain set voltage parameters.
With DVC Voltage Correction Off,
feedback from the arc is not used
for closed-loop feedback
maintain voltage parameters.
Feedback from the arc is still used
for other functions.
Be sure voltage sensing leads are
connected.
1 Auxiliary Output
This output can be set to several
1
conditions:
On whenever the wire feeder is op-
erating
On during the welding arc until arc
goes out
On during the entire weld cycle
Off or never On.
1 Voltage Feedback Display
The Internal setting allows the unit
to obtain voltage feedback directly
from the welding power source out-
put terminals.
When using the V. Sense setting,
arc voltage feedback is through the
voltage sense leads connected to
the feeder. Use this setting when
there is more than 50 ft (15 m) of
weld cable used or when using
Touch Sensor.
to
to