Table of Contents
Advertisement
System Reset
Voltage (Control Feedback)
Arc Start/Volt Sense Shutdown
Wire Feed Mode
4-2. Lower Front Panel Controls
CE
1
Power Switch
.
The fan motor is thermostatically
controlled and only runs when cooling is
needed.
4-3. Meter Functions
Note
The meters display the actual weld output values for approximately three seconds after the arc
is broken.
Mode
MIG
Pulsed
MIG
By selecting system reset in the memory reset mode, the unit defaults to original factory settings for
all programs and all set up excluding System, Arc Time, and Model Type.
Allows voltage to be monitored at the output terminals by two methods. This can be selected through
the internal connections of the unit, or through the unit's external voltage sense lead.
When using the V. Sense setting, arc voltage feedback is through the voltage sense leads connected
to the feeder. Use this setting when there is more than 50 ft (15 m) of weld cable used.
When this feature is on, the system immediately shuts down if no arc voltage is sensed. An error
message is displayed. When this feature is off, wire feeds even when there is no arc voltage sensed.
Allows the selection of inches per minute or meters per minute for wire feed speed. This mode is also
used to select motor type; standard speed, low speed, or high speed.
1
2
Voltmeter (see Section 4-3)
Meter Reading At Idle
V
24.5
Preset Volts
V
PPP
Pulse Display
2
3
A
Blank
A
PPP
Pulse Display
3
Ammeter (see Section 4-3)
Meter Reading While Welding
V
A
24.5
250
Actual Volts
Actual Amps
V
A
24.5
250
Actual Volts
Actual Amps
OM-196 188 Page 21
Ref. 186 067
Advertisement
Table of Contents
Troubleshooting
