Icom IC-7200 Advanced Instructions page 110

Previous view
10
SET MODE
Items in the Set mode (Continued)
■
Scan Speed
Sets the speed at which channels or frequencies are
scanned during scanning.
High and low can be selected.
HI : Fast scan
Lo : Slow scan
Scan Resume
This item turns the scan resume function ON or
OFF.
on : Scan resumes 10 seconds after stopping on
a signal (or 2 seconds after a signal disap-
pears).
oF : Scan does not resume after stopping on a sig-
nal.
Main Dial Auto TS
Sets the auto tuning step function so that when ro-
tating [DIAL] rapidly, the tuning step rate adapts as
selected.
Set to HI (Fastest) or Lo (Faster) tuning speed, or to
oF (OFF).
HI : Approximately 5 times faster when the tuning
step is set to 1 kHz or smaller steps; approxi-
mately 2 times faster when the tuning step is
set to 5 kHz or larger steps.
Lo : Approximately 2 times faster
oF : Auto tuning step is turned OFF.
Dial ¼
Turn the ¼-speed tuning function ON or OFF in the
CW, RTTY and SSB data modes.
on : The ¼-speed tuning function is ON for critical
tuning. While operating in the CW/RTTY/SSB
data mode, the dial sensitivity is reduced to ¼
of normal.
oF : The ¼-speed tuning function is OFF.
NOTE: This function is only usable when the Quick
tuning function is OFF (p. 3-7).
Mic Up/Down Speed
Sets the rate at which frequencies are scanned when
the microphone [UP]/[DN] keys are used.
HI : High speed (50 tuning steps/second)
Lo : Low speed (25 tuning steps/second)
10-13
High (default)
ON (default)
High (default)
OFF (default)
High (default)