Define the type of the folding device
Define the type of the folding device
Introduction
You must first set the [Finisher type], see
In case you have a folding device configured as finisher device, you can specify the type of the
folding device.
Procedure
1.
Navigate to [Configuration] - [Printer setup] - [Finishing].
2.
Click on the [Folder configuration] setting.
The default value is [No folding device installed]
3.
Select the appropriate type of the folding device:
• [Cross folder]
• [Cross folder with conveyor belt]
• [Cross folder with reinforcement unit]
• [Cross folder with conveyor belt and reinforcement unit]
• [Fan folder]
4.
Click [Ok] to confirm your entries or [Cancel] to reject your entries.
154
Chapter 3 - Define your Workflow with Océ Express WebTools
Define the finisher type on page
153.