Removing The Expansion Card Riser - Dell PowerEdge R330 Owner's Manual

Card priority Card type
4 1 Gb NICs
5 Non-RAID

Removing the expansion card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Lift and rotate the expansion card riser latch to open it.
2. Holding the touch points, lift the expansion card riser from the riser connector on the system board.
Slot priority
Qlogic 1
QLE2562,
Qlogic
QLE2560,
Emulex
LPE12002,
Emulex
LPE12000,
Emulex
LPE15000, and
Emulex
LPE15002 Low
Profile
Intel and 2
Broadcom Dual
and Quad Port
Intel and 1
Broadcom Dual
and Quad Port
Low Profile
12GB SAS HBA 2
Full Height
12GB SAS HBA 1
Low Profile
Safety instructions.
Before working inside your system.
Maximum allowed
1
1
1
1
1
85