Installing The Lcd Control Panel Assembly - Dell PowerEdge R330 Owner's Manual

Figure 57. Removing and installing the LCD control panel board—four hard drive chassis
1. screw (2)
3. display module cable
5. USB connector cable
Next steps
1. Install the LCD control panel assembly.
2. Follow the procedure listed in
Related Tasks

Installing the LCD control panel assembly

Installing the LCD control panel assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Align the tabs on the control panel with the notches on the chassis.
2. Route the LCD cable through the cable retention clip.
After working inside your
Safety instructions.
Before working inside your
2. control panel connector cable
4. control panel board
6. standoff on the chassis (2)
system.
system.
121