Panasonic WJ-HD100 Operating Instructions Manual page 28

2. Rotate the JogDial to select ON or OFF, then press the
JogDial.
ON: Buzzer beeps while alarm is active.
OFF: Buzzer does not beep.
Motion Detector Setup
306 VMD SETUP
VDM stands for Video Motion Detector that senses the
changes of video signals in the preset area, and supplies
alarm output. Once the change is detected the recorder
starts recording. The sensitivity setting and area setting for
detection are made on this window.
ALARM SETUP
REC MODE
REC RATE
REC QUALITY
DURATION
ALARM BUZZER
VMD SETUP
1. Move the cursor to VMD AREA SETUP with the up [ ]
and down [ ] buttons.
2. Rotate the JogDial to select the desired parameter, then
press the JogDial. The default is OFF.
[LOW ↵]: VMD is enabled with low sensitivity.
[MID ↵]: VMD is enabled with mid sensitivity.
[HIGH ↵]: VMD is enabled with high sensitivity.
[OFF]: Motion detection is disabled.
The area setup window appears with an asterisk when
other than OFF is selected. The asterisk represents the
up-left or bottom-right of the detection area. The divi-
sion lines are not displayed actually on the monitor.
28
SF- 12H
15FPS
10(1-10)
10S
ON
OFF
Notes:
• VMD should be used with an ordinary camera input to
the unit. Select [OFF] to avoid useless VMD when a
video multiplexer or combination camera supplies the
input to the unit.
• Place the date and status display to the other position
than the motion detection area on the monitor.
Otherwise the date and status display may mislead the
motion detector.
• Set the ALARM SUSPEND to ON with the LCD button
when VMD is unneccessarily activated during the VMD
setup.
3. Set the up-left end of the detection area. Move the
asterisk to the left or right with the JogDial, and up or
down by pressing the up [ ] and down [ ] buttons.
REW/FF
/
STEP
/
PUSH PAUSE
•
/
4. Press the JogDial to enter the up-left end. The asterisk
position is highlighted.
5. Set the bottom-right end of the detection area as same
operations as step 3 and 4 above.
6. Press the JogDial. The area is highlighted.
Up to 4 areas are set even they overlap in part together.
Repeat from step 3 to 6 when more areas are set.
To cancel the entered area, move the cursor to the up-
left end of the area, then press the JogDial.
q
SET
/
e
w
r