Table of Contents
Advertisement
To set motorcycle load:
Press and hold button 1 re-
peatedly until desired setting is
displayed.
The load setting cannot be
adjusted while the motorcy-
cle is underway.
The following settings are avail-
able:
One-up
Two-up
Mirror removal and
installation
Removing mirror
Push cover cap 1 upward.
Loosen nut 2 with tool from
onboard tool kit.
When removing the right-
hand mirror, make sure that
the brake-fluid reservoir is not
detached.
Remove mirror 3.
Retighten nut 2 with tool from
onboard toolkit.
Installing mirrors
Install mirror 3.
Tighten nut 2 with tool from
onboard toolkit.
Locknut (mirror) on
clamping piece
Joint compound: Multi-Wax
Spray
15 lb/ft (20 Nm)
Slide on cover cap 1.
5
83
z
Advertisement
Table of Contents
