Battery - BMW 2013 S 1000R Rider's Manual

terminal while connecting
the other end to discharged
battery's negative terminal.
Start engine of the vehicle with
discharged battery in usual
way; if engine does not start,
wait a few minutes before re-
peating attempt in order to pro-
tect starter motor and donor

battery.

Allow both engines to idle for a
few minutes before disconnect-
ing jumper cables.
Disconnect jump lead from
negative terminals first, then
disconnect second lead from
positive terminals.
Installing driver`s seat (

Battery

Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential for
recognition of warranty claims.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
Keep the surface of the battery
clean and dry
Do not open the battery
Do not top up with water
Be sure to read and comply
with the instructions for charg-
ing the battery on the following
pages
Do not turn the battery upside
down.
If the battery is not discon-
nected, the onboard elec-
tronics (clock etc.) will drain the
battery. This can cause the bat-
61).
tery to run flat. If this happens,
warranty claims will not be ac-
cepted.
During driving breaks of more
than 4 weeks, a trickle-charger
should be connected to the
battery.
BMW Motorrad has devel-
oped a trickle-charger spe-
cially designed for compatibility
with the electronics of your mo-
torcycle. Using this charger, you
can keep the battery charged
during long periods when the
motorcycle is not being used
without having to disconnect the
battery from the motorcycle's
onboard systems. Additional in-
formation is available at your au-
thorized BMW Motorrad retailer.
Disconnecting battery
from motorcycle
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Removing rider`s seat (
9
149
z
61).