Huawei AP8030DN Installation And Maintenance Manual page 91

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide
Figure 5-75 Installing a new mould in the COAX crimping tools
Keep the short side of the mould inwards and the long side outwards, with the teeth of the mould
aligning from the larger size to the smaller size.
Step 5 Hold the handles of the COAX crimping tools tightly to match the mould and the jaw completely.
Align the screw holes, as shown in
Figure 5-76 Aligning the screw holes
Step 6 Hold the handles of the COAX crimping tools with one hand. Tighten the two fastening screws
in the clockwise direction.
crimping tools.
Issue 02 (2014-12-05)
NOTICE
Figure 5-77
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-76.
and Figure 5-78shows the mould installed in the COAX
5 Appendix
85