Huawei AP8030DN Installation And Maintenance Manual page 66

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide
Figure 5-28 Components of an unshielded RJ45 connector and cable
A. Plug of connector
Procedure
Step 1 Remove a 16-mm (0.63 in.) long section of the jacket, as shown in
When you remove the shield layer, do not damage the insulation of the twisted-pair cable.
Figure 5-29 Removing the jacket of a twisted-pair cable (unit: mm (in.))
Step 2 Align the four pairs of wires and cut the ends neatly, as shown in
between the wires and the pins are listed in
Figure 5-30 Connections between wires and pins (unit: mm (in.))
Pin 8
Issue 02 (2014-12-05)
A
C
NOTICE
Pin 1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
B
B. Jacket
Table 5-6.
White-Orange
Orange
White-Green
Blue
White-Blue
Green
White-Brown
Brown
C. Twisted-pair wires
Figure 5-29.
Figure 5-30. The connections
C
16
5 Appendix
60