Huawei AP8030DN Installation And Maintenance Manual page 60

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide
Context
Figure 5-15
Figure 5-15 Shielded RJ45 connector and cable
A. Jacket of connector
E. Jacket of Ethernet cable F. Shield layer of Ethernet cable G. Twisted-pair wires
Procedure
Step 1 Fit the jacket of the connector onto the Ethernet cable, as shown in
Figure 5-16 Fit the jacket of the connector onto the Ethernet cable
Step 2 Remove a 30 mm (1.18 in.) long section of the jacket, cut off the nylon twine inside the jacket,
and cut a no more than 5 mm (0.20 in.) cleft in the jacket, as shown in
Issue 02 (2014-12-05)
shows the components of an RJ45 connector and a shielded Ethernet cable.
B. Metal shell of connector
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
C. Wire holder of connector D. Plug of connector
Figure
Figure
5 Appendix
-
5-16.
5-17.
54