Huawei AP8030DN Installation And Maintenance Manual page 55

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide
Procedure
Step 1 Based on the cross-sectional area of the cable conductor, strip a part of the cable. The L-long
conductor is exposed, as shown in
5-2.
l When you strip a power cable, do not damage the conductor of the cable.
l If the bare crimping terminal is not provided by Huawei, you can adjust the value of L as
Figure 5-7 Stripping a power cable (JG terminal)
Table 5-2 Mapping between the cross-sectional area of the conductor and the value of L
Cross-Sectional Area of Conductor
(mm
16 (0.025)
25 (0.039)
35 (0.054)
50 (0.077)
Step 2 Put the heat shrink tubing onto the bare crimping terminal, as shown in
Issue 02 (2014-12-05)
NOTICE
required.
2 2
(in. ))
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-7. The recommended values of L are listed in
Value of L (mm(in.))
13 (0.51)
14 (0.55)
16 (0.63)
16 (0.63)
5 Appendix
Table
Figure 5-8.
49