Huawei AP8030DN Installation And Maintenance Manual page 9

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide
Table 1-1
Table 1-1 Descriptions of interfaces
No.
1
2
3
4
5
6
7
8
9
10
Issue 02 (2014-12-05)
Default
Console
6 7
describes interfaces on the AP8030DN and AP8130DN.
Name
GE0/PoE
GE1
SFP
5 GHz antenna
interface
2.4G/5G
Console
Default
Security slot
Device ground screw Connects a ground cable to the AP.
Ground screw for the
surge protective
device
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AP8130DN & AP8030DN Overview
8
Description
10/100/1000M bit/s interface: connects to the
wired Ethernet. The interface can connect to
a PoE power supply to provide power for the
AP.
10/100/1000M bit/s interface: connects to the
wired Ethernet. The interface can't connect to
a PoE power supply to provide power for the
AP.
Connects an optical fiber to the AP. An
optical module must be installed first.
Connects a 5 GHz antenna to the AP.
2.4 GHz or 5 GHz antenna interface.
Console: Console interface
Reset button: restores factory settings and
restarts the AP if you hold down the Reset
button for more than 3 seconds.
NOTE
The Reset button is protected by a waterproof
screw. Before pressing the Reset button, remove
the waterproof screw. Keep the screw properly and
install it again after pressing the Reset button.
Connects to a security lock.
Connects the AP to the ground point of an
external surge protective device.
3