Mercedes-Benz 2007 E 320 BLUETEC Operator's Manual page 95

Safety and Security
Occupant safety
2 Hook
3 Anchorage ring
Swing rear seat backrest to the rear un-
til it engages.
Check the rear seat backrest to be
locked in its upright position
( page 412).
Once the top tether anchorage hook is
attached, the child restraint itself can be
secured.
Install the child restraint system and
tighten the top tether strap according
to the child restraint manufacturer's in-
structions.
94
Child seat anchors - LATCH type
This vehicle is equipped with two LATCH
(Lower Anchors and Tethers for CHildren)
type anchors (at each of the outer rear
seats) for the installation of a "LATCH"
child seat with the matching mounting fit-
tings.
The anchors are located behind an uphol-
stery blend.
1 Indicates the position of the anchors
2 Anchors
Lift up upholstery blend to access the
anchors 2.
Install child seat according to the
manufacturer's instructions.
!
Make sure the seat belt for the center seat
can operate freely with a child seat installed.
i
Non-LATCH type child seats may also be
used and can be installed using the vehicle's
seat belt system ( page 88). Install child seat
according to the manufacturer's instructions.