Mercedes-Benz 2007 E 320 BLUETEC Operator's Manual page 197

Controls in detail
Automatic transmission
If you have selected the AMG menu in the
control system and you are driving in the
manual program mode M, upshift
indicator 2 in the multifunction display
advises you to upshift before the engine
reaches the overspeed range. Thus you
can drive at the maximum engine speed for
each gear without overrevving the engine.
1 Gear indicator
2 Upshift indicator
Shift to the next higher gear.
The fuel supply will otherwise be inter-
rupted to prevent the engine from over-
revving.
196
Downshifting
Warning!
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced
vehicle control. Your vehicle's ABS will not
prevent this type of loss of control.
Briefly press the gear selector lever to
the left in the D- direction.
or
Briefly pull left shift paddle 1
( page 193).
The transmission shifts to the next
lower gear.
i
When you brake or stop, the transmission
shifts down to a gear from which you can easily
accelerate or take off.
Kickdown
Using the kickdown when driving in the
G
manual program mode M is not possible.
Deactivating manual shift program
Press the program mode selector
switch ( page 195) repeatedly
until C or S appears in the multifunction
display.
or
Restart the engine.
The transmission will go to the
automatic program mode (C or S).
The manual program mode M is not
stored.