Mercedes-Benz 2007 E 320 BLUETEC Operator's Manual page 239

Controls in detail
Power windows
i
Operating the windows from the rear is not
possible if you activate the override switch
( page 95).
i
With the SmartKey in starter switch
position 0 or removed from the starter switch,
the windows can be operated:
until you open the driver's or front passen-
ger's door
for at least 5 minutes
Switch on the ignition ( page 37).
Opening the windows
Press switch 1 to 4 to the resistance
point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
Pull switch 1 to 4 to the resistance
point.
The corresponding window will move
upwards until you release the switch.
238
Warning!
If you pull and hold the switch up when clos-
ing the window, and upward movement of
the window is blocked by some obstruction
including but not limited to arms, hands, fin-
gers, etc., the automatic reversal will not op-
erate.
Fully opening the windows
(Express-open)
Press switch 1 to 4 past the resis-
tance point and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
Pull switch 1 to 4 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
G
Warning!
Driver's door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not operate.
!
If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly.
Remove the obstruction, pull the respective pow-
er window switch again past the resistance point
and release.
If the window still does not close when there is
no obstruction, pull and hold the respective pow-
er window switch. The window will then close
without the obstruction sensor function.
Stopping windows during Express-op-
eration
Press or pull the respective power win-
dow switch again.
G