Viewing Cordless Module Information; Auto Dial - Mitel 5360 User Manual

Viewing Cordless Module Information

You can use the Cordless Module Application to view protocol, firmware, and hardware
information about the module.
To view cordless module information
1. Access the Cordless Module Application.
2. Press Cordless Module Info. Device information appears on the screen.
3. Press Close to exit.

Auto Dial

When a Cordless Module is installed and at least one device is paired, the Auto Dial feature
is available in the Settings menu. You can program a number that is automatically dialed
when a cordless device hookswitch button is pressed.
To program an Auto Dial number:
1. Press Settings.
2. Press Auto Dial, and then press Edit Number.
3. In the on-screen keyboard, enter the autodial number.
4. Press Save.
5. Press Edit Label.
6. In the on-screen keyboard, enter the appropriate information.
7. Press Save and then press Close.
To disable Auto Dial:
1. Press Settings.
2. Press Auto Dial.
3. Press Disable Auto Dial. The Auto Dial settings you have programmed are maintained
when the feature is disabled.
4. Press Save.
To re-enable, repeat steps 1 and 2 and then press Enable Auto Dial.
x
To change Auto Dial information, press Edit Number and/or Edit Label.
x
Press Save to save all changes.
x
- 88 -