Cordless Module Led Indicators; Using A Cordless Device As A Remote Control - Mitel 5360 User Manual

indicating that the accessory is charging. It could take up to 60 minutes for the green
LED to start flashing. Allow the accessory to fully charge, approximately 3 hours.
4. Press Yes to confirm pairing. The Cordless Devices application confirms the pairing by
displaying the paired device name and its battery level indicator.
5. Press Close to exit.
To unpair a cordless accessory:
1. Press the Menu
2. Press the device name that you want to unpair. The information screen for the selected
device appears.
3. Press Unpair this Device. If the accessory is in use, an error message is displays.
Otherwise, the accessory is unpaired, removed from the display, and can no longer be
used to interact with the phone.
4. Press Close.
For more information about the Cordless Devices Application, see page 87.

Cordless Module LED Indicators

The Cordless Module has a blue light-emitting diode (LED) that indicates the current status of
the module (See Figure 1):
Blue LED
Solid
Blinking
Off
Solid for 2 seconds
Blinking: LED is On and Off for equal amount of time

Using a Cordless Device as a Remote Control

When not being used to talk, the cordless handset/headset buttons can act as a remote
control device to change display contrast, volume, and mute settings on the host IP phone.
For example, in a remote handsfree conference setting, the chairman can use the volume
and mute buttons on a cordless device to adjust speaker levels and mute the microphone on
an IP phone that is not within his reach. HTML applications may also make use of the
cordless device buttons but functionality may differ among applications.
key and then press Cordless Devs.
Audio is active between the module and either the handset or headset.
Pairing mode is active or a firmware upgrade is in progress.
No audio is active.
Pairing is successful.
- 81 -
5360 IP Phone – User Guide
Function