Tag Call; Trunk Flash - Mitel 5360 User Manual

For the 5360, when a user presses a programmable key which is in the alternate speed dial
number state:
The programmable key text will change to display the primary number for two seconds
x
giving you the option to dial the primary number
If you press the button again while the primary number is displayed, the primary number
x
will be dialed; otherwise, the alternate number will be automatically dialed after the two
second timeout.

Tag Call

Tag Call allows you to signal that you are the victim of a threatening or malicious call. Using
the tag, your system administrator or Telephone Company can identify the source of the call
and provide this information to appropriate personnel or authorities.
CAUTION: Tagging a non-malicious call may result in fines or other penalties.
To tag a malicious call:
1. Press the programmed Tag Call key while the call is in progress. For information on how
to program keys, see to Programming Features On Your Keys
-OR-
Press
2. Dial the appropriate feature access code.
If the call was successfully tagged, Thank You is shown on the display; otherwise, Not
Allowed is displayed.
Note: Tag Call can be used on active two-party calls only. Calls on hold and conference
calls cannot be tagged.

Trunk Flash

The Trunk Flash feature allows you to access Centrex features (if available) while you are
talking on an outside call.
To flash a trunk while talking on an outside call:
1. Press the key you have programmed to Flash.
Note: You can program a key to single flash or double flash.
2. Wait for dial tone.
3. Dial the Centrex feature access code.
(TRANS/CONF).
- 73 -
5360 IP Phone – User Guide